Tono-Pen use - Revision history

Danbot: Add References

2026-03-22T09:32:46Z

Add References

← Revisión anterior		Revisión del 09:32 22 mar 2026
Línea 29:		Línea 29:
	*[[Acute angle closure glaucoma]]		*[[Acute angle closure glaucoma]]
	*[[IOP]]		*[[IOP]]
			==References==
			<references/>

	[[Category:Procedures]]		[[Category:Procedures]]
	[[Category:Ophthalmology]]		[[Category:Ophthalmology]]

Blsimpso at 21:52, 29 June 2021

2021-06-29T21:52:52Z

← Revisión anterior		Revisión del 21:52 29 jun 2021
Línea 31:		Línea 31:
	[[Category:Procedures]]		[[Category:Procedures]]
	[[Category:Ophthalmology]]		[[Category:Ophthalmology]]

			==External Links==

			===Videos===
			{{#widget:YouTube\|id=sBosdQ6o1oY}}

ClaireLewis: /* See Also */

2019-10-10T15:52:45Z

ClaireLewis: /* See Also */

2016-07-14T23:56:43Z

ClaireLewis: /* See Also */

2016-07-14T23:56:03Z

Rossdonaldson1: /* To Calibrate */

2016-07-11T05:32:41Z

To Calibrate

← Revisión anterior		Revisión del 05:32 11 jul 2016
Línea 15:		Línea 15:
	#If “bAd”, repeat the calibration again.		#If “bAd”, repeat the calibration again.

			===If unsuccessful===
	*If ~~this is all~~ unsuccessful~~, options~~ include		Options include:
	**cleaning the tip (compressed air is recommended)		*clean the tip (compressed air is recommended)
	**change the batteries. Use the little probe that came with the Pen to open the		*change the batteries.
	**battery compartment.		**Use the little probe that came with the Pen to open the battery compartment.
	**Tech Support		*Tech Support
	***www.reichert.com		**www.reichert.com
	***www.tonopen.us		**www.tonopen.us
	***1-888-849-8955		**1-888-849-8955

	==See Also==		==See Also==

	[[Category:Procedures]]		[[Category:Procedures]]

Rossdonaldson1: /* To Use (if already calibrated */

2016-07-11T05:31:40Z

To Use (if already calibrated

← Revisión anterior		Revisión del 05:31 11 jul 2016
Línea 1:		Línea 1:
	==To Use (if already calibrated==		==To Use (if already calibrated)==
	*Depressing the Operator Button ONCE		*Depressing the Operator Button ONCE
	*Monitor should show TWO lines (====).		*Monitor should show TWO lines (====).

Rossdonaldson1: /* To Calibrate */

2016-07-11T05:31:29Z

To Calibrate

← Revisión anterior		Revisión del 05:31 11 jul 2016
Línea 24:		Línea 24:
	***www.tonopen.us		***www.tonopen.us
	***1-888-849-8955		***1-888-849-8955

			==See Also==

	[[Category:Procedures]]		[[Category:Procedures]]

Rossdonaldson1: /* CALIBRATION */

2016-07-11T05:31:16Z

CALIBRATION

← Revisión anterior		Revisión del 05:31 11 jul 2016
Línea 1:		Línea 1:
	==~~CALIBRATION~~==		==To Use (if already calibrated==
	*The Pen should be calibrated if the batteries have been changed or if the LCD reads “CAL” followed by		*Depressing the Operator Button ONCE
	*“- - - -”.		*Monitor should show TWO lines (====).
	*~~Remember, calibration~~ involves depressing the Operator Button TWICE and getting ONE		*Use on eye
	*line (- - - -). ~~To take a reading requires depressing the Operator Button ONCE and getting~~
	*~~TWO lines (====).~~		==To Calibrate==
	*1. Point the transducer end straight down towards the floor.		*The Pen should be calibrated if the batteries have been changed or if the LCD reads “CAL” followed by “- - - -”.
	*2. Press the Operator Button “distinctly, two times, within 1.5 seconds.”		*Calibration involves depressing the Operator Button TWICE and getting ONE line (- - - -).
	*3. Initially “CAL” appears on the LCD, followed by “UP” (after about 15 - 30 seconds!)		*If so,
	*4. Invert the transducer end to point straight up toward the sky.		*#Point the transducer end straight down towards the floor.
	*5. A properly functioning Pen will display “”Good”.		*#Press the Operator Button “distinctly, two times, within 1.5 seconds.”
	*If “bAd”, repeat the calibration again.		*#Initially “CAL” appears on the LCD, followed by “UP” (after about 15 - 30 seconds!)
			*#Invert the transducer end to point straight up toward the sky.
			#A properly functioning Pen will display “”Good”.
			#If “bAd”, repeat the calibration again.


	*If this is all unsuccessful, options include		*If this is all unsuccessful, options include
	*cleaning the tip (compressed air is recommended)		**cleaning the tip (compressed air is recommended)
	*change the batteries. Use the little probe that came with the Pen to open the		**change the batteries. Use the little probe that came with the Pen to open the
	*battery compartment.		**battery compartment.
	*Tech Support		**Tech Support
	*www.reichert.com		***www.reichert.com
	*www.tonopen.us		***www.tonopen.us
	*1-888-849-8955		***1-888-849-8955

	[[Category:Procedures]]		[[Category:Procedures]]

Rossdonaldson1 at 08:47, 19 May 2016

2016-05-19T08:47:22Z

← Revisión anterior		Revisión del 08:47 19 may 2016
Línea 1:		Línea 1:
	==CALIBRATION==		==CALIBRATION==
	The Pen should be calibrated if the batteries have been changed or if the LCD reads “CAL” followed by		*The Pen should be calibrated if the batteries have been changed or if the LCD reads “CAL” followed by
	“- - - -”.		*“- - - -”.
	Remember, calibration involves depressing the Operator Button TWICE and getting ONE		*Remember, calibration involves depressing the Operator Button TWICE and getting ONE
	line (- - - -). To take a reading requires depressing the Operator Button ONCE and getting		*line (- - - -). To take a reading requires depressing the Operator Button ONCE and getting
	TWO lines (====).		*TWO lines (====).
	1. Point the transducer end straight down towards the floor.		*1. Point the transducer end straight down towards the floor.
	2. Press the Operator Button “distinctly, two times, within 1.5 seconds.”		*2. Press the Operator Button “distinctly, two times, within 1.5 seconds.”
	3. Initially “CAL” appears on the LCD, followed by “UP” (after about 15 - 30 seconds!)		*3. Initially “CAL” appears on the LCD, followed by “UP” (after about 15 - 30 seconds!)
	4. Invert the transducer end to point straight up toward the sky.		*4. Invert the transducer end to point straight up toward the sky.
	5. A properly functioning Pen will display “”Good”.		*5. A properly functioning Pen will display “”Good”.
	If “bAd”, repeat the calibration again.		*If “bAd”, repeat the calibration again.
	If this is all unsuccessful, options include		*If this is all unsuccessful, options include
	cleaning the tip (compressed air is recommended)		*cleaning the tip (compressed air is recommended)
	change the batteries. Use the little probe that came with the Pen to open the		*change the batteries. Use the little probe that came with the Pen to open the
	battery compartment.		*battery compartment.
	Tech Support		*Tech Support
	www.reichert.com		*www.reichert.com
	www.tonopen.us		*www.tonopen.us
	1-888-849-8955		*1-888-849-8955

	[[Category:Procedures]]		[[Category:Procedures]]

← Revisión anterior		Revisión del 15:52 10 oct 2019
Línea 28:		Línea 28:
	*[[Eye pain]]		*[[Eye pain]]
	*[[Acute angle closure glaucoma]]		*[[Acute angle closure glaucoma]]
			*[[IOP]]
	[[Category:Procedures]]		[[Category:Procedures]]
			[[Category:Ophthalmology]]

← Revisión anterior		Revisión del 23:56 14 jul 2016
Línea 26:		Línea 26:

	==See Also==		==See Also==
			*[[Eye pain]]
	*[[Acute angle closure glaucoma]]		*[[Acute angle closure glaucoma]]
	[[Category:Procedures]]		[[Category:Procedures]]